Home :: Standards & Conformance :: DCC
September 20, 2004
A
draft proposal
was made available.
September 12, 2004
This topic describes a recommended way of wiring the small connector
so that lamps continue to work in DC mode in both directions. This wiring
also provides a symmetric load.
The intention is to put this recommended wiring into an appendix of
RP 9.1.1 so that manufacturers will know about it, and may use it or not
without affecting the conformance of their product.
Reinhard Mueller
will coordinate this topic. As this is a recommendation, not a requirement,
this topic should move quickly. This topic was created on
September 12, 2004.
